PR TANGO 750 FRAMING Manual page 7

●GOBO FILTER REPLACEMENT
Lock the tilt and loosen the 4 fast-fit screws on the upper cover ,After removing the cover, you will see the structures as the figure above.
To replace a gobo on the rotating gobo wheel: take the rotator from the wheel in the sequence of
rotator by removing the tightening spring. Put the new gobo back to the rotator, then tighten it with the spring. Please ensure the spring is
in the narrow location of the rotator, which is the internal ring of it and flatten it.At last, pull up the spring strip using proper tool and put
the rotator back to the wheel with the assistance by another hand. Its installation is of the opposite sequence of removal(
NOTE: Do not touch the glass gobo with bare hand. Place clean and soft paper or cloth between hand and glass gobos.
Tighten 4 inner hexagon screws after the cover is on. Unlock the tilt.
●FIXING THE FRAMING MODULE
Remove the small cover after locking Tilt after adjusting the framing blades. Unplug the plug on the left after tightening the
screw against the module till it can't move . At last, install the small cover.
If the framing blades need to be adjusted, plug the plug into its original place after loosening the tightening screw, then repeat
Step 1.
Rotating gobo wheel
Gobo assembly
Plug
7
1→2 , take the gobo out from the
（2→1） .
Rotator
Gobo
Spring
Tightening screw for module
rotation