Setupand Configuration - PR TANGO 100 BEAM Manual

electrical noise from disturbing and corrupting the DMX control signals.
The DMX terminator is simply an XLR connector with a 120 (ohm) resistor connected across pins 2 and 3, which is then plugged
into the output socket on the last projector in the chain. The connections are illustrated below.

4. SETUPAND CONFIGURATION

● FRONT PANELOPERATION
The projector's functions and start address can be conveniently set via buttons and LCD screen.
To browse through or modify the projector's functions, press key ENTER for more than 2 seconds to unlock the control panel and the
screen displays its function menu. Each main function menu has its sub-menus, and each submenu stands for its respective function.
For the details, please see the following:
To set or browse through the projector's functions, press key UP or DOWN.
Press the key ENTER to save your settings or enter into the submenus. Press key UP or DOWN to change values(plus or minus)
Press key FUNC, it will return to the upper menu. If the key not pressed, the system will go back to display status automatically.
● DMX STARTADDRESS
Each Projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to "listen" to the digital control information being sent out from the
controller. The Unit has 1 DMX modes, which is standard mode. For standard mode, it has 8 channels, so set the No. 1 projector's
address 001, No. 2 projector's address 09, No. 3 projector's address 017, No. 4 projector's address025, and so on.
Launch the projector. Press button ENTER more than 3seconds to unlock panel.
Press button ENTER to display DMX address;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm; after powered on next time, the default will be last value saved
Press button FUNC, it will return to the upper menu
.
● STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within
● MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture's DMX output to the second fixture's DMX input using XLR-XLR control cable and then connect the second
fixture's DMX output to the third fixture's DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture's DMX output to a DMX terminator. Set 1
DMX TERMINATOR
2
1
Connect a 120
across pins 2 and 3 in an XLR plug
3
and insert into the DMX out socket
120
on the last unit in the chain.
512.
projector as the master and others are Slaves.
st
CONNECTION
(OHM) resistor
7
PIN 2
PIN 3