5. SETUPAND CONFIGURATION
●
FRONTPANELOPERATION
To browse through or view a projector's function settings, push any key to activate the screen after power-on.. After screen
unlocked, push both key and to enter into menus. Each main menu has its sub-menus with different special functions, for
detailspleasesee the 5
point hereinafterOPERATIONMENU.
th
1、Undermenupagefor functionsettings,push
2、During menu operation
▲
▼
or
submenus,push
back to initial displayautomatically.
DMX STARTADDRESS
●
Push any key to enter into options interface.
If multiple projectors are controlled by DMX controller, each projector must have its own DMX address to receive DMX signals from the
controller and respond to them. The projector has 2 DMX modes. There are short mode and standard mode. For example standard mode
has 27 channels, so set the No. 1 projector's address 001, No. 2 projector's address 028, No. 3 projector's address 055, No. 4 projector's
address82 and so on.
Turn on a projector and push any key to enter into options interface
SelectCHANNELMODE iconand pushENTER key
▲
Push key UP
or DOWN
OK
PushENTER key
▶
PushESCAPE key
to enter intoupper level menus.
STAND-ALONEMODE
●
Without connecting a projector with a controller via XLR cable, after preset memories under the master mode enabled, it
will run in Stand-Alone mode.
MASTER/SLAVEMODE
●
(1) Edit the scene desired
Twowaysto edit scene
a.
Editmanually
Disconnect a projector from XLR cable and enter into scene editing via control panel.A scene has 20 steps and select any step via its
sequence No.. Enter into channel control to edit its data. After disconnected from a DMX controller, a projector will respond to data
editedsimultaneously.
b.
Editwith helpof a DMX controller
Use a DMX controller to control a projector. After the projector is controlled properly in positions, select the sequence No. of step to
be saved and click to store DMX values.
Current DMX data will be automatically saved to its scene's data and the sequence NO. added 1. And so on, it can save 20-step scene.
(2) Selectusemode from scenemenu.Thereare2 modesfor selection:singleand recycle.If not used,it can be closed.
▲
▶
OK
key is to escape,
key to change values(plus or minus). Push
▼
to set value desired.
it.
to confirm
▼
or
to selectfunctiondesired.
key means ENTER,push
▶
OK
. SelectDMXADRESS in 2
10
OK
key to save settings or enter into
key to go backto upper menu.If not, the screenwill go
nd
level menu to set start address