PR TANGO 750 FRAMING Manual page 6

The size of the screws are to be decided by the customer based on the size of mounting holes in the arms, the following sizes in the table
are only for reference
NO
1 Inner hexagon screw
2
POWER CONNECTION
●
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Before power connection, please ensure the power supplied must match what the nameplate says. It is recommended that each
projector be connected with power separately so that they may be individually switched on and off.
●The earth wire(yellow/green) must be connected to the ground.And electrical connection must be in
accordance with the standards concerned.
●If any questions about the electrical installation, do not continue but consult a qualified electrician.
●A projector uses naked wires. For wiring please use waterproof junction box with IP class not lower
than IP66.
THE WIRING OFCONTROLSIGNAL
●
The colors of signal wires responds to their respective functions:
Blue color –A+
White color –B-
Black color –Shield wire
The shielded 2-core wire between a projector and a controller or between projectors should be not less than 0.5mm in diameter
and the maximum number of projectors in a DMX chain should be less than 32 pieces.
DMX TERMINATOR
●
In the Controller mode, at the last fixture in the chain, its female DMX output has to be connected with a DMX terminator.
The DMX terminator is simply a Canon connector with a 120 (ohm) resistor connected across pin A+ and pin B-, which prevents
electrical noise from disturbing and corrupting the DMX control signals. Before DMX terminator connection, please make proper
insulation and waterproof treatment.
NAME
Coupled with the inner
Washer
hexagon screws
SIZE QTY
M12 3
3
6
REMARKS
Prepared by the customer
Prepared by the customer