Parts And Components; Before Use - cecotec CONGA HAND CARPET&SPOT CLEAN 2500 Instruction Manual

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Main body
2. Function buttons
3. Solids tank
4. Suction tube
5. Water spray nozzle
6. Motorised brush
7. Waste-water tank
8. Clean-water tank
Buttons and indicator lights
Fig. 2
1. Power button
2. Water spray button
3. Motorised brush button
4. Battery indicator light
Please note
The graphics in this manual are schematic representations and may not exactly match the
appliance.

2. BEFORE USE

- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Battery
Please note that the built-in battery is not charged from factory, so make sure to fully charge
it before using the appliance. (Note: always use the device-specific charger to charge it).
1. Place the vacuum horizontally on a table.
2. Before charging the appliance make sure it is switched off. Then, plug the charger into the
appliance charging port (the charging socket is protected by a sliding cover that slides up
58
CONGA HAND CARPET&SPOT CLEAN 2500