Table of Contents
Advertisement
Table 3.L
Switch SW3 Settings for Datalink D
SW3-5
Off
On
Table 3.M
Switch SW3 Settings for Duplicate Message Detection
SW3-6
Off
On
Table 3.N
Switch SW3 Settings for Application Timeout Default Value
SW3-8
SW3-7
Off
Off
Off
On
On
Off
On
On
NOTE: The Application Timeout defaults to the value set by switches
SW3-7 and -8. The default value is used for Application Timeout unless
the user writes a value to the Application Timeout address in the
Communications Module Data Table. If power is removed the default value
is reloaded upon powerup.
Chapter 3
Installation
Function
Disable Datalink D Messaging
Enable Datalink D Messaging
Duplicate Message Detection
Disable Duplicate Message Detection
Enable Duplicate Message Detection
Application Timeout Value
No Timeout (Disabled)
1 Second
30 Seconds
60 Seconds
3-9
Advertisement
Table of Contents
