Isobus Task Controller Icons - Tume SUPER NOVA COMBI 3000 User Manual

Pressing the tramline settings icon (icon 2, picture 26) opens tramline settings. Upper number
shows distance between tramlines. In the picture above it is 20 m. Lower numbers, 1 / 5 in the
picture, the first number shows the current way line and the second the total number of way lines
( = how often the tramlines are made). You can change the values by pressing + and – buttons
below the numbers.
Way line can be changed also by pressing the quick buttons.
Next way line.
Previous way line.
Tramlines are made when the current way line is halfway of the total way lines. Tramlines are
made for example in the following situations

2/3

3/5

4/7

5/9 etc.
Making tramlines is started from way line 1. For example, when you start to go around the field.
Then you need to make sure that the way line is the same the whole round. This can be done by
pressing tramline and marker counter off (section 11.2.16). Way line is 1 also when started to
seed back and forth starting from the edge of the field.
+1/2 function allows you to transfer asymmetric tramlines to symmetric tramlines. In practice first
round on the field is sown with half width of the machine (see sections 11.2.6 Halving left and
11.2.7 Halving right). After the first round the whole working width is used. Now tramlines are
formed e.g. a four-meter drill and a 24 meter sprayer, in way line 4/6.
If the +1/2 function is not activated (icon is grey) and the ratio of the sprayer width to the drill
width is an even number, e.g. a 24 meter sprayer and a 4 meter drill → 24/4 = 6, the tramlines
are always asymmetrical. In this case, the machine makes at step 3/6 the second half of the
tramline and in step 4/6 the second half.
While making asymmetric tramlines, these icons are used to select the driving method, going
around the field or back and forth. Changing the driving direction is done by pressing the icon for
a while when direction of the arrow changes.

11.2.3 ISOBUS task controller icons

ISOBUS task controller is controlled from the tractor's ISOBUS terminal settings
(picture 26). Icons are for the user's information and cannot be activated/disabled from
the seeding menu.
To use the different features of the task controller, they must be activated from the
tractor's terminal. Refer to the tractor's manual how to do this. These functions are only
available if the tractor is equipped with these features.
33