Section 4 - Operating Instructions; Controls And Instrument Identification - Scag Power Equipment SWZT-36H-14FS Operator's Manual

Section 4
WARNING
Do not attempt to operate this mower unless you
have read this manual. Learn the location and
purpose of all controls and instruments before
you operate this mower.
4.1 CONTROLS AND INSTRUMENT
IDENTIFICATION
Before operating the mower, familiarize yourself with all
mower and engine controls. Knowing the location, function
and operation of these controls is important for safe and
efficient operation of the mower.
1. Ignition Switch (Figure 4-1). The ignition switch
is used to start the engine. Turn the key to the on
position before pulling the recoil starter.
ADJUSTMENT LEVER
OPERATING INSTRUCTIONS
CUTTER DECK
RELEASE LEVER
CUTTER HEIGHT
ENGINE THROTTLE
CONTROL
ENGINE CHOKE
CONTROL
LEFT STEERING
CONTROL
HOUR METER
OPERATOR PRESSENCE
CONTROL
NEUTRAL LATCH
SPEED CONTROL
LEVER
Figure 4-1. Controls and Instruments
2. Mower Deck Switch (Figure 4-1). Use to engage
and disengage the mower drive system. Pulling up
on the switch will engage the deck drive. Pushing
down on the switch will disengage the deck drive.
3. Engine Choke Control (Figure 4-1). Use to start a
cold engine.
4. Engine Throttle Control (Figure 4-1). Use to
control the engine speed. Pushing the lever forward
increases engine speed. Pulling the lever back
decreases engine speed. Full back position is the
IDLE position. Full forward is the cutting position.
5. Left Steering Control (Figure 4-1). Use to control
the mower's left wheel when traveling forward or
reverse. Pull upward for neutral and reverse.
6. Right Steering Control (Figure 4-1). Use to control
the mower's right wheel when traveling forward or
reverse. Pull upward for neutral and reverse.
BRAKE LEVER
IGNITION
RIGHT STEERING
SWITCH
CONTROL
OPERATOR PRESSENCE
CONTROL
MOWER DECK
SWITCH
NEUTRAL LATCH
11
R