Makita VC011G Instruction Manual page 21

Disposing of dust
When dust has accumulated up to the full line of the
dust case, follow the procedure below and dispose of
the dust.
Hold the dust case firmly, press and hold the two
1.
buttons, and remove the dust case.
2
Fig.51
► 1 . Full line 2. Dust case 3. Button (two locations)
4. Mesh filter
2. Dispose of the dust inside the dust case and
remove any dust and powder adhered to the surface of
the mesh filter.
3. Insert the dust case all the way until the two but-
tons lock with a click.
2
Fig.52
► 1 . Dust case 2. Button (two locations)
NOTE: Check that the cyclone attachment, cleaner,
and straight pipe are locked properly before restarting
operation.
NOTE: If the suction force does not recover even
after disposing of the dust and cleaning the mesh
filter, check whether dust has accumulated in the dust
bag of the cleaner or clogging has occurred.
1
4
3
1
Cleaning
When the dust case becomes dirty or the mesh filter is
clogged, remove and wash them with water. (Refer to
"Disposing of dust" for the removal procedure.)
Dry the parts thoroughly before reinstallation and use.
1
Fig.53
► 1 . Dust case 2. Mesh filter
When the mesh filter gets dirty badly, clean it in the
following procedures.
Turn the mesh filter counterclockwise and remove
1.
it while the hooks are unlocked.
Fig.54
► 1 . Mesh filter 2. Hook
Remove the dust on the mesh filter and then wash
2.
it with water. After that, dry it thoroughly.
21 ENGLISH
2
1
2