Table of Contents
Advertisement
MAINTENANCE
NOZZLE MAINTENANCE
SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, carefully remove them.
CLEANING THE SOFT ROLLER
Slide the Soft Roller access button
forward to release the Soft Roller.
CORD MAINTENANCE
To minimize the risk of power cord damage,
DO NOT run the vacuum over the power cord.
If this occurs, immediately shut off power to
the vacuum and remove the cord from the
brushrolls or nozzle.
s h a r kc l e a n . c o m
Hand wash the Soft Roller as needed.
Use only water, and allow it to air-dry
completely for at least 24 hours. Reinsert
the Soft Roller in the front of the nozzle
until it clicks into place.
1.
DO NOT pull or carry vacuum cleaner by
the cord or use cord as a handle.
2.
DO NOT unplug by pulling on the cord.
Grasp the plug, not the cord.
3.
DO NOT close the door on the cord.
4.
DO NOT pull the cord around sharp
corners.
5.
DO NOT leave the cord near heated
surfaces.
CHECKING FOR BLOCKAGES
DUST CUP BLOCKAGES
Detach dust cup from vacuum
pod. Empty dust cup and remove
debris from lint screen in the top
of the dust cup.
HOSE BLOCKAGES
Detach hose from handle by
pressing on the release button
at the top of the hose. Detach
the hose from the pod, and
check openings for blockages.
NOZZLE BLOCKAGE
Detach wand from floor nozzle,
tilt nozzle neck back, and check
opening for blockages.
WAND BLOCKAGES
Detach wand from pod and handle,
and check both ends for blockages.
HANDLE/HOSE BLOCKAGE
Detach handle from wand and
hose from the vacuum pod, and
check openings for blockages.
NOZZLE HOSE BLOCKAGE
To access the nozzle hose, pinch
the release touchpoints on the
bottom of the nozzle, then lift the
cover and clear any blockages.
s h a r kc l e a n . c o m
Advertisement
Table of Contents
