Fayat Group BOMAG BMF 2500 M Service Manual page 23

1.2.6.2 Working on hydraulic lines
1.2.6.3 Working on the engine
General – Concerning your safety
Use only the intended access steps and grips to mount the
machine.
For overhead maintenance work use the access steps and working
platforms provided or other secure means.
Do not step on machine parts which are not intended for this pur-
pose.
Do not leave any tools or other objects, that could cause damage,
in or on the machine.
After all maintenance work is completed reinstall all guards and
safety installations.
Close all maintenance flaps and doors after maintenance work has
been completed.
The terms right/left are always in relation to the
travel direction.
Relieve hydraulic pressures before working on hydraulic lines.
Hydraulic oil escaping under pressure can penetrate the skin and
cause severe injury. Immediately call for medical advice when
injured by hydraulic oil.
Do not step in front of or behind the wheels/track chains when per-
forming adjustment work in the hydraulic system.
Do not change the setting of pressure relief valves.
Drain the hydraulic oil at operating temperature – danger of
scalding!
Any hydraulic oil must be collected and disposed of in an environ-
mentally friendly way.
Always collect and dispose of hydraulic oils separately.
Do not start the engine after draining off the hydraulic oil. Once all
work is completed (with the system still depressurized!) check all
connections and fittings for leaks.
Hydraulic hoses must be visually inspected at regular intervals.
Do not mix up hoses by mistake.
Only genuine BOMAG replacement hydraulic hoses ensure that
the correct hose type (pressure range) is used at the right location.
Do not work on the fuel system while the engine is running -
danger to life due to high pressures!
Wait until the engine has stopped, then wait approx. another 15
minutes.
BMF 2500 M 23