Advertisement
Safety regulations
Environment
It is strictly prohibited to drain off oil into the soil,
the sewer system or into natural waters. Old oil
must be disposed of according to applicable envi-
ronmental regulations. If in doubt you should con-
sult your local authorities.
Hydraulics
Always relieve the pressure in the hydraulic system
l
before disconnecting any lines. Hydraulic oil escap-
ing under pressure can penetrate the skin and
cause severe injury.
Always make sure that all screw fittings have been
l
tightened properly and that hoses and pipes are in
mint condition before pressurizing the system
again.
Hydraulic oil leaking out of a small opening can
l
hardly be noticed, therefore please use a piece of
cardboard or wood when checking for leaks. When
injured by hydraulic oil escaping under pressure
consult a physician immediately, as otherwise this
may cause severe infections.
Do not step in front of or behind the drums, wheels
l
or crawler tracks when performing adjustment work
in the hydraulic system while the engine is running.
Block drums, wheels or crawler tracks with wedges.
Reattach all guards and safety installations after
all work has been completed.
Environment
It is strictly prohibited to drain off oil into the soil,
the sewer system or into natural waters. Oil oil
must be disposed of according to applicable envi-
ronmental regulations. If in doubt you should con-
sult your local authorities.
Fuels
Danger
!
Repair work shall only performed by appropriately
trained personnel or by the after sales service of
BOMAG.
Follow the valid accident prevention instructions when
handling fuels.
The following notes refer to general safety precau-
tions for danger free handling of fuel.
Fuel vapours not only are easily inflammable, but also
highly explosive inside closed rooms and toxic; dilu-
tion with air creates an easily inflammable mixture.
The vapours are heavier than air and therefore sink
down to the ground. Inside a workshop they may eas-
ily become distributed by draft. Even the smallest por-
tion of spilled fuel is therefore potentially dangerous.
008 917 09
Fire extinguishers charged with FOAM, CO
l
or POWDER must be available wherever fuel is
stored, filled in, drained off, or where work on fuel
systems is performed.
The vehicle battery must always be disconnected,
l
BEFORE work in the fuel system is started. Do not
disconnect the battery while working on the fuel
system. Sparks could cause explosion of the fuel
fumes.
Wherever fuel is stored, filled, drained off or where
l
work on fuel systems is carried out, all potential ig-
nition sources must be extinguished or removed.
Search lights must be fire proof and well protected
against possible contact with running out fuel.
Hot fuels
Please apply the following measures before draining
of fuel to prepare for repair work:
Allow the fuel to cool down, to prevent any contact
l
with a hot fluid.
Vent the system, by removing the filler cap in a well
l
ventilated area. Screw the filler cap back on, until
the tank is finally emptied.
Synthetic rubber
Many O-rings, hoses, etc. are made of synthetic ma-
terial, a so-called fluorocarbon elastomer. Under nor-
mal operating conditions this material is safe and does
not impose any danger to health.
However, if this material becomes damaged by fire or
extreme heat, it may decompose and form highly
caustic hydrofluoric acid, which can cause severe
burns in contact with skin.
If the material is in such a state it must only be
l
touched with special protective gloves. The protec-
tive gloves must be disposed of according to appli-
cable environmental regulations immediately after
use.
If the material has contacted the skin despite these
l
measures, take off the soiled clothes and seek
medical advice immediately. In the meantime cool
and wash the affected area of skin over a sufficient
time with cold water or lime water.
Poisonous substances
Some of the fluids and substances used are toxic and
must under no circumstances be consumed.
Skin contact, especially with open wounds, must be
avoided.
These fluids and substances are, amongst others,
anti-freeze agents, hydraulic oils, fuels, washing addi-
tives, refrigerants, lubricants and various bonding
agents.
BOMAG
1.2
2
GAS
11
Advertisement
