Be Cool saturn Manual page 17

EN
3.5- ADJUST THE LENGTH OF HARNESS
Loosen the harnes 14. The harness can be slackened
by pressing the adjuster(under the seat cover
the front of the seat. Press down the adjuster as you
grip the two harness with your another hand. Pull the
harness towards you to loosen the harness.
Tighten the harness 14. Pull the harness upward to
remove the slack from the lap sections of the harness
then pull the front stretch belt until the harness is fully
tightened.
* The harness should be adjusted as tightly as possible
without causing discomfort to your child. A loose
harness can be dangerous.
* Check the harness adjuster and tighten each time
when the child is placed in the seat.
3.6- THE METHOD TO STORE SHOULDER STRAPS WITH
CHEST PAD AND BUCKLE
* Suitable for children in height 105-150cm.
(1, 2, 3) Storage of buckle. (4, 5, 6) Storage of shoulder
32
straps and sleeves.
1) Press red button to release the buckle
2) Take the buckle out of the crotch pad.
on
11
3) Then lift the seat cover, pull out the buckle from the
cover hole, and put it into the seat groove for storage.
4) Tear the Velcro of the two shoulder sleeves
buckle inserts in order and store them in the shoulder
sleeves.
5) Loosen the snap button on both sides of the hea-
drest cover to expose the internal structure of the seat,
and store the sorted shoulder sleeves in the grooves
inside the seat, as shown in 6
3. 7- USAGE OF THE SUPPORT LEG
When child height in 40-105cm, the support leg is in
the usage state
-Lift the bottom of the seat and push the support leg
forward from the groove with your hand.
-Push it to the front end and then take the support leg
19,out, let it is perpendicular to the ground and hear a
sound of "click" .
8 -The method to adjust the length of the support leg 19.
Press and hold the adjustment button on the support
leg 15, then adjust the length up and down until it hits
the car ground. The bottom of the support leg will turn
green.
put the
5
* When child height in 105-150cm, the support leg is in
the stowed state.
Note: When puting away the support leg, press and
hold the bottom support leg first to prevent loosening,
and push the front end of the support leg in at the
same time.
3.8- ADJUST THE ISOFIX ATTACHMENTS
20 First install the two ISOFIX guide sleeves to the
ISOFIX attachment of the vehicle (If your vehicle seat is
equipped with ISOFIX guide sleeves).
19
The ISOFIX attachments can be adjusted for many
positions to fit the different positions of ISOFIX low
anchorages expending from car seat.
Press down the release button
attachment of both sides to the longest. Snap the
ISOFIX into the ISOFIX guide sleeve.
Make sure that you have heared a "click" and the
ISOFIX latching indication shows GREEN.
If you want to release the ISOFIX attachments, jus-
tinstallation of the ISOFIX attachments is finished.
Push the red release button of the ISOFIX chuck at
the direction as shown, the ISOFIX chuck will be
released.
* After installed the ISOFIX chuck, push the child
restraint forwards until it is tight against the car seat.
Now, the ISOFIX base is installed in place.
3.9- THE METHOD OF ROTATE SEAT
Find the rotation adjuster butto 13, lift up and
rotate the body at the same time (both sides can be
rotated).
When you hear a sound of "click", the rotation
adjuster automatically retracts, indicating that the
17 to adjust ISOFIX
gear is in place.
EN
33