HP 250 Operating page 85

HP 2608 Printer
Paper is loaded through the bottom of the HP 2608A.
it, perform the following sequence of steps:
To load
1) Position the paper supply inside the printer stand against
left side alignment bracket.
2) Pull the platen release lever toward you to open the platen.
3)
Open the access cover; then open both tractors. If a
different form or horizontal position is required, unclamp
both tractors so they may be adjusted to a different width.
The tractors should be positioned so that paper may be pushed
up into the printer without hitting the open tractor doors.
NOTE
An interlock prevents printing when the
platen is open. A fault indication is
displayed on the control panel by the
PLATEN/RIBBON Fault Indicator during
paper loading and adjustment.
4)
Push the paper up into the printer from below until it
appears above the print mechanism; then pull the paper up
until the holes can be matched to the tractor lugs. Make
certain the paper is not skewed to either side. Close the
tractors. Push the platen release lever to close the platen.
If the forms thickness has been changed, use the Platen
Adjust Knob to adjust the gap for maximum print quality.
5)
Clamp the tractors in place on the tractor guide shaft if
previously released.
6) When the printer runs out of paper, it stops at Top Of Form.
It is only necessary to use the FORM FEED switch to advance
the printer to the Top Of Form position if paper out did not
occur.
6-6
HP 2608 Printer
Paper is loaded through the bottom of the HP 2608A.
it, perform the following sequence of steps:
To load
1) Position the paper supply inside the printer stand against
left side alignment bracket.
2) Pull the platen release lever toward you to open the platen.
3)
Open the access cover; then open both tractors. If a
different form or horizontal position is required, unclamp
both tractors so they may be adjusted to a different width.
The tractors should be positioned so that paper may be pushed
up into the printer without hitting the open tractor doors.
NOTE
An interlock prevents printing when the
platen is open. A fault indication is
displayed on the control panel by the
PLATEN/RIBBON Fault Indicator during
paper loading and adjustment.
4)
Push the paper up into the printer from below until it
appears above the print mechanism; then pull the paper up
until the holes can be matched to the tractor lugs. Make
certain the paper is not skewed to either side. Close the
tractors. Push the platen release lever to close the platen.
If the forms thickness has been changed, use the Platen
Adjust Knob to adjust the gap for maximum print quality.
5)
Clamp the tractors in place on the tractor guide shaft if
previously released.
6) When the printer runs out of paper, it stops at Top Of Form.
It is only necessary to use the FORM FEED switch to advance
the printer to the Top Of Form position if paper out did not
occur.
6-6