Changing A Disc Cartridge; Shutdown Procedure - HP 250 Operating
Hide thumbs
Also See for 250:
- User manual (89 pages) ,
- Specification (22 pages) ,
- Technical white paper (8 pages)
Table of Contents
Advertisement
Storage Devices and Media
Changing a Disc Cartridge
To change a disc cartridge, perform the following sequence:
1)
If the disc drive is operating, set the RUN/STOP switch to
STOP.
The DRIVE READY indicator will go out immediately.
2 )
A 11 ow the s pin dIe t
0
hal t
( 3 0 sec
0
n d s
0
r 1 e s s ) •
Th e D0 OR
UNLOCKED indicator will light indicating that the cartridge
access door may be opened.
3)
Open the cartridge access door by pulling out and down on its
recessed upper edge.
4)
Firmly grasp the disc cartridge and slowly pull it straight
out.
5)
Carefully insert the new disc cartridge, access-door end
first,
until it is seated fully.
Use only an HP 12940A
Formatted Disc Cartridge.
6)
Close the cartridge access door.
7)
Set the RUN/STOP switch to RUN to resume operation.
Shutdown Procedure
To shut down the disc drive, proceed as follows:
1)
Set the RUN/STOP switch to STOP.
will go out immediately.
The DRIVE READY indicator
2 )
A 11 ow the s pin dIe t
0
hal t
( 3 0 sec
0
n d s
0
r 1 e s s ) •
Th e D0 OR
UNLOCKED indicator will light indicating that the cartridge
access door may be opened and the cartridge removed,
if
desired.
3)
Push in on the bottom edge of the control panel access door
to open it.
4)
Set the POWER/OFF switch to the OFF position.
The Unit
Select Identification and DOOR UNLOCKED indicators will go
out.
5-12
Storage Devices and Media
Changing a Disc Cartridge
To change a disc cartridge, perform the following sequence:
1)
If the disc drive is operating, set the RUN/STOP switch to
STOP.
The DRIVE READY indicator will go out immediately.
2 )
A 11 ow the s pin dIe t
0
hal t
( 3 0 sec
0
n d s
0
r 1 e s s ) •
Th e D0 OR
UNLOCKED indicator will light indicating that the cartridge
access door may be opened.
3)
Open the cartridge access door by pulling out and down on its
recessed upper edge.
4)
Firmly grasp the disc cartridge and slowly pull it straight
out.
5)
Carefully insert the new disc cartridge, access-door end
first,
until it is seated fully.
Use only an HP 12940A
Formatted Disc Cartridge.
6)
Close the cartridge access door.
7)
Set the RUN/STOP switch to RUN to resume operation.
Shutdown Procedure
To shut down the disc drive, proceed as follows:
1)
Set the RUN/STOP switch to STOP.
will go out immediately.
The DRIVE READY indicator
2 )
A 11 ow the s pin dIe t
0
hal t
( 3 0 sec
0
n d s
0
r 1 e s s ) •
Th e D0 OR
UNLOCKED indicator will light indicating that the cartridge
access door may be opened and the cartridge removed,
if
desired.
3)
Push in on the bottom edge of the control panel access door
to open it.
4)
Set the POWER/OFF switch to the OFF position.
The Unit
Select Identification and DOOR UNLOCKED indicators will go
out.
5-12
Advertisement
Table of Contents
