Table of Contents
Advertisement
Safety Information
•
After completing the installation, always carry out a
functional test and provide the instructions on how to
operate the air conditioner to the user.
•
Do not use the air conditioner in environments with
hazardous substances or close to equipment that release
free flames to avoid the occurrence of fires, explosions
or injuries.
•
Our units should be installed in compliance with the
spaces shown in the installation manual, to ensure
accessibility from both sides and allow repairs
or maintenance operations to be carried out. The
unit's components should be accessible and easy to
disassemble without endangering people and objects.
For this reason, when provisions of the installation
manual are not complied with, the cost required to
access and repair the units (in SAFETY CONDITIONS, as
set out in prevailing regulations) with harnesses, ladders,
scaffolding or any other elevation system will NOT be
considered part of the warranty and will be charged to
the end customer.
Power supply line, fuse or circuit
breaker
WARNING
•
Always make sure that the power supply is compliant
with current safety standards. Always install the air
conditioner in compliance with current local safety
standards.
•
Always verify that a suitable grounding connection is
available.
•
Verify that the voltage and frequency of the power
supply comply with the specifications and that the
installed power is sufficient to ensure the operation of
any other domestic appliance connected to the same
electric lines.
•
Always verify that the cut-off and protection switches
are suitably dimensioned.
•
Verify that the air conditioner is connected to the power
supply in accordance with the instructions provided in
the wiring diagram included in the manual.
•
Always verify that electric connections (cable entry,
section of leads, protections...) are compliant with the
electric specifications and with the instructions provided
in the wiring scheme. Always verify that all connections
comply with the standards applicable to the installation
of air conditioners.
4
English
•
Devices disconnected from the power supply should be
completely disconnected in the condition of overvoltage
category.
•
Be sure not to perform power cable modification,
extension wiring, and multiple wire connection.
– It may cause electric shock or fire due to poor
connection, poor insulation, or current limit override.
– When extension wiring is required due to power line
damage, refer to "Step 12 Optional: Extending the
power cable" in the installation manual.
CAUTION
Make sure that you earth the cables.
•
Do not connect the earth wire to the gas pipe, water
pipe, lighting rod or telephone wire. If earthing is not
complete, electric shock or fire may occur.
Install the circuit breaker.
•
If the circuit breaker is not installed, electric shock or
fire may occur.
Make sure that the condensed water dripping from the
drain hose runs out properly and safely.
Install the power cable and communication cable of
the indoor and outdoor unit at least 1m away from the
electric appliance.
Install the indoor unit away from lighting apparatus
using the ballast.
•
If you use the wireless remote control, reception error
may occur due to the ballast of the lighting apparatus.
Do not install the air conditioner in following places.
•
Place where there is mineral oil or arsenic acid. Resin
parts flame and the accessories may drop or water may
leak. The capacity of the heat exchanger may reduce or
the air conditioner may be out of order.
•
The place where corrosive gas such as sulphuric acid gas
generates from the vent pipe or air outlet.
•
The copper pipe or connection pipe may corrode and
refrigerant may leak.
•
The place where there is a machine that generates
electromagnetic waves. The air conditioner may not
operate normally due to control system.
•
The place where there is a danger of existing
combustible gas, carbon fibre or flammable dust.
•
The place where thinner or gasoline is handled. Gas may
leak and it may cause fire.
Advertisement
Table of Contents
