Samsung AC TNCDKC Series Installation Manual page 16

Installation Procedure
Step 13 Setting the indoor unit
addresses and the installation options
• Set the indoor unit address and installation option
with remote controller option. Set the each option
separately since you cannot set the ADDRESS setting
and indoor unit installation setting option at the same
time. You need to set twice when setting indoor unit
address and installation option.
• Please use the proper wireless remote controller
which can set 24 digit option code.
• Please refer to the wired remote controller
installation manual for setting with the wired remote
controller.
Common steps for setting the addresses and
options
Entering mode
for setting
option
High Temp Button
Low Temp Button
NOTE
• The remote control display and buttons may vary
depending on the model.
16
English
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
b While holding down the
c Make sure that you are entered to the mode for
2 Set the option values.
• The total number of available options are 24: SEG1 to
Option setting
SEG24.
mode
• Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
Mode change
• Set a 2-digit value for each option pair in the
High Fan Button
following order: SEG2 and SEG3 → SEG4 and SEG5
→ SEG6 and SEG8 → SEG9 and SEG10 → SEG11 and
Low Fan Button
SEG12 → SEG14 and SEG15 → SEG16 and SEG17 →
SEG18 and SEG20 → SEG21 and SEG22 → SEG23 and
SEG24
SEG1
0
SEG7
1
SEG13
2
SEG19
3
and then insert them again.
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
setting the options:
CAUTION
SEG2 SEG3 SEG4
X X
SEG8 SEG9 SEG10
X X
SEG14 SEG15 SEG16
X X
SEG20 SEG21 SEG22
X X
On (SEG1 to SEG12)
(High Temp) and
SEG5 SEG6
X X X
SEG11 SEG12
X X X
SEG17 SEG18
X X X
SEG23 SEG24
X X X
Off (SEG13 to SEG24)