Advertisement
Pairing
①
②
Correct pairing will be confirmed by temporary switching off of the output
③
circuit and the LED will turn on again.
The remote control is programmed with the roller blind controller on the ba-
sis of pairs of buttons. For FW-RC5 and FW-RC10 transmitters the subsequ-
ent buttons are paired. For example, if the button "1" on the remote control
is paired with the receiver, then for the opposite direction of movement the
④
subsequent button "2" will be automatically paired.
For FW-RC4 transmitter are paired buttons that are vertically adjacent. For
example, if the button "1" on the remote control is paired with the receiver,
then for the opposite direction of movement button "3" will be automati-
cally paired.
The receiver can be paired with eight different transmitters (remote buttons).
Pairing with more buttons will remove the first entries made.
Unpairing
To clear the list of transmitters cooperating with the receiver, press the PROG button and hold it
down for at least 10 seconds. Fast flashing of communication LED will indicate that the memory
of the controller has been cleared.
After the device is properly connected, press and
hold the PROG button until the relay will switch on
and the communication LED will go off.
Press the selected button on a remote control or in
a flush-mounted transmitter.
- 4 -
Advertisement
