Table of Contents
Advertisement
How to Program the Player to Pause or Scan Automatically
There are many functions you can program the Multi Disc Player to do automatically. Two of them are Auto Pause and
Intro Scan. To make the player stop every time a selection ends, use Auto Pause. When you want to find a particular
track, use the INTRO button to make the player play the first 8 seconds (approximately) of each chapter or track on the
CD, LD, or CDV.
Locate the AUTO PAUSE and INTRO buttons on the Remote Commander.
To Make the Player Stop
Momentarily (Auto Pause) .......
To Resume Normal Playback ....
AUTO PAUSE
AUTO PAUSE
a
Press AUTO PAUSE on the Remote.
When the current selection ends, the player
pauses.
To play the next selection, press PLAY ( > ).*
To display "A. PAUSE" on the TV screen, press
DISPLAY twice. If you have pressed DISPLAY
once, "A. PAUSE" appears for three seconds,
then disappears.
T- 2
f- 1 0:10
Pun
AUDIO
1-10 40:29
123
4
5
6 7
8 910
A.PAUSE
STANDARD
Press AUTO PAUSE again.
To Scan the Beginning of Each
Chapter/Track (Intro Scan) .......
To Resume Normal Play ..........
To Stop Play .......................
INTRO
STOP
Press INTRO on the Remote.
The player plays only the first 8 seconds
(introduction) of each chapter or track on the
disc.** When playing an LD, the player pauses
after introducing the last chapter on side B of
the disc. On CDVs, intro-scanning starts from
the video section of the disc.
Press CLEAR.
Play resumes from the selection just introduced.
Press STOP (@).
* In Single Repeat mode, the same selection starts playing again. In Repeat A-B mode, playback starts from the point
marked "A".
** In stop mode, intro-scanning starts from the first chapter or track on the disc. If you press INTRO while playing a
chapter or track, scanning starts from the next one. If you press INTRO while the player is introducing a chapter or
track, the scanning skips to the next one.
38
To Play Any Disc
Advertisement
Table of Contents
