Sony MDP-800 Operating Instructions Manual page 2

Owner's Record
The model number is located on the rear panel. The
serial number is located on the top of front panel. Record
the model number and the serial number in the space
provided below. Refer to them whenever you call upon
your Sony dealer regarding this product.
Model No.
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
Serial No.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This symbol is intended to alert the user
to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient
magnitude to constitute a risk of electic
shock to persons.
This symbol is intended to alert the user
to the presence of important operating
and maintenance (servicing) instructions
in the literature accompanying the
appliance.
For detailed safety precautions, see the leaflet
"IMPORTANT SAFEGUARDS".
This CD CDV LD player is classified as a CLASS 1
LASER product.
CAUTION
The use of optical instruments with the product will
increase eye hazard.
As the laser beam used in this videodisc player is
harmful to the eyes, do not attempt to disassemble
the cabinet. Refer servicing to qualified personnel
only.
For the Customers in the USA
INFORMATION
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur ina
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV
technician for help.
For the Customers in CANADA
This apparatus complies with the Class B limits for radio
noise emissions set out in radio Interference
Regulations.
CAUTION:
TO PREVENT ELECTRIC SHOCK, DO NOT USE
THE POLARIZED AC PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE FULLY INSERTED
TO PREVENT BLADE EXPOSURE.