Changing Front Panels.24-26 - KitchenAid Superba 4KUDS220T Use And Care Manual

Changing Front Panels
Your new KitchenAid dishwasher comes with
a stainless steel trim kit and two front panels
installed one behind the other. You can
choose from almond or white (front and back
of one panel) and black or harvest wheat
(front and back of the second panel).
If you want to change the colour of the
panels, follow one of the options below:
OPTION A may be used if your dishwasher
front protrudes several inches from the cabinets.
OPTION B may be used if your dishwasher
front is flush with the cabinets.
Electrical Shock Hazard
Disconnect electrical power supply to
dishwasher before changing panels.
Failure to do so could result in
electrical shock or personal injury.
OPTION A
Upper Panel:
1. Disconnect electrical power supply.
2. Pull door open and on either side of the
dishwasher door, remove the three
screws (A) from the trim (B). Remove the
loosened piece of trim.
3. Slide the colour panel out. Handle carefully
so the panel will not be scratched or
bent. Turn the panel to the desired
colour. Place the colour panel in position
then push the filler panel in behind it.
4. Replace the trim (B) and the three screws (A).
Lower Panel:
1. Remove the two screws (C) on either side
of the lower panel. Remove the loosened
piece of trim (D).
2. Slide the colour panel out. Handle carefully
so the panel will not be scratched or bent.
Turn the panel to the desired colour.
Place the colour panel in position then
push the filler panel in behind it.
3. Replace the trim (D)'and the two screws (C).
4. Reconnect electrical power supply.
24