Menu Settings; Menu Navigation; User Menu (In Segments) - OHAUS Defender 2500 Instruction Manual

Defender 2500

4. MENU SETTINGS

The User Menu allows the users to customize the terminal settings.
4.1

Menu Navigation

4.1.1 User Menu (In segments)

C.A.L S.E.t.u.P r.E.A.d
ZErO reset reset
SpaN C.Unit Stable
LIN CAP ZErO
GEO Grad FIltEr
C.test P.ZerO AZt
ENd P.UNIt B.LIGHt
A.tare SCreeN
ENd A.Off
P.SaUer
ENd
NOTE:
1. The following menus will not appear until the corresponding accessories are installed.
U.S.B
The will appear if you connect the terminal into a PC with the USB type-C. And you can select

HID CDC
the or
P.r.i.n.t.U
The

NOTE: Refer to Section 6.1.1
2. Some modes/units may not be available in all models.
When LEGAL FOR TRADE is turned ON (the security switch S1 is in the locked position), the menu
settings will be affected as below:
• Calibration function is disabled.
Zero Range setting is locked at 2%.
•
• Stable Range setting is locked at 1d.
Auto-Zero Tracking setting is locked at 0.5d.
•
Filter and Units are locked at their current settings.
•
• Stable Only is locked at On.
:
Lb oz unit is only for postal use if it is available.
•
Power saving mode is disabled.
•
Peak Hold mode is disabled.
•
• Counting mode: Sample number selection 5 will not be available.
NOTE: Refer to 5.3 Sealing for the position of the security switch S1.
mM.O.d.E U.N.I.t r.s.2.3.2 P.r.i.n.t
reset reset
g
wWeIGH
COUNt
kg
PkHd
lb
tOtAL
oz
tAble
lb:oz
dyNamM
t
d.typE
ENd
d.start
d.tImME
A.tImME
ENd
type.
will appear if you select
for the USB communication settings.
U.S.B
reset reset reset
BAud ASSIGN type
PAritY DEmMAN
ON.StAb
StOP
ON.ACEP ALt.P
H.SHAKE
INtEr
ALt.t
ALt.P
mMt.Con
ALt.Z
ALt.t
OH.Con
ENd
ALt.Z
SICS
ENd
Stable
CONtNt
LAYOUt
ENd
CDC
type.
P.r.i.n.t.U L.o.c.k
reset reset
ASSIGN L.ALL
HID DEmMAN L.OFF
CDC ON.StAb
L.ZErO
ON.ACEP
L.Print
INtEr
L.Unit
mMt.Con
L.mModE
OH.Con
L.mMeNU
SICS
L.tArE
Stable
ENd
CONtNt
LAYOUt
ENd
EN-13
E.n.d