Table of Contents
Advertisement
VL SERIES STEAMERS - REMOVAL AND REPLACEMENT OF PARTS
HEATER CONTACTORS
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1.
Open the cabinet base doors, remove the two
screws from the contactor box cover and lift
cover off.
2.
Disconnect the electrical lead wires to the coil
and the power supply wires from the contactor
being replaced.
3.
Remove the screws form the base of the
contactor and lift out.
4.
Reverse procedure to install and check for
proper operation.
HEATING ELEMENTS
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
1.
Open the cabinet base doors, remove the two
screws from the contactor box cover and lift
cover off.
2.
Disconnect the electrical lead wires to the
element being replaced.
3.
Remove the bolts securing the heating element
flange to the boiler and lift the element out.
4.
Clean the mating surface of the boiler and
install a new flange gasket and heating
element.
5.
Check for leaks and proper operation.
REGENERATED STEAM MODELS
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AT THE MAIN
CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT
BOX INDICATING THE CIRCUIT IS BEING
SERVICED.
WARNING: SHUT OFF THE STEAM SUPPLY
BEFORE SERVICING THE UNIT.
1.
Disconnect pipe unions in the steam supply line
to the coils and in the condensate discharge
line from the coils.
2.
Remove header that supplies steam to the coils
by disconnecting union at each coil.
3.
Remove coil condensate collection header.
4.
Remove bolts securing the coil being replaced
and pull coil forward.
5.
Clean the mating surfaces of the steam coil
flange and the boiler.
6.
Reverse procedure to install a new steam coil
and gasket.
7.
Check steamer for proper operation.
Page 21 of 88
(STEAM COIL)
Advertisement
Table of Contents
