Wash Cycles; Soil Level - Sears Kenmore Elite 630.1399 Series Use & Care Manual

WASH CYCLES
CYCLE
SmortWosh
TM
HE
Takes the guesswork out of cycle selection. The sensors
in the dishwasher automatically adjust the cycle length,
temperature and water changes based on the soil
load. This cycle contains additional sensor decisions
when compared to other cycles.
SOiL LEVEL
Light - Medium
Heavy
TiME (rains.)
Without options
Typical
105
130
Gallons
3.3
125
5.2
12.6
19.8
Pots & Pans _
Cleans items having baked-on or hard dried food soils. Light - Medium
These items may require soaking or hand scouring. Heavy
110
125
125
135
4.8
6.3
18.1
23.7
Normal Wash
Thoroughly cleans normal loads having loosely
attached normal soiling.
Light - Medium
Heavy
95
125
125
150
2.3
6.4
8.7
24.2
Chino Gentle
Designed to be used with your fragile china and
glassware, allowing you to get it perfectly clean
without the hassle of hand washing or worry of
damage in the dishwasher.
Light - Medium
Heavy
8O
85
85
9O 3.8
11.3
14.4
Fast Wash
Cleans lightly soiled dishes and reduces overall wash
All Soil Levels 59 59 3.7 14.1
time. Use this cycle to clean glasses and dessert dishes
that may need to be re-used at the same event
Adding options will increase or decrease the cycle time. See " Cycle Options" information section.
This is a sanitizing cycle.
Sonltlze Cycle Informatlon
A dishwasher cycle that is a sanitizing cycle has been tested
to meet very strict performance requirements of wash time
and water temperature to ensure dishware and kitchenware
sanitization. These performance requirements are explained
in the document NSF/ANSI 184, Residential Dishwashers.
The sanitizing dishwasher cycles are marked in the chart
above with an asterisk. When these cycles are complete, the
"Sanitized" indicator on your dishwasher control panel will
illuminate.
However, if your household water supply is too hot your
dishwasher's heating time may be reduced, and the
Sanitized indicator may not illuminate.
The cycle times listed in the Use and Care Manual are
based on normal soil loads and 120°F incoming water and
will vary based on your actual conditions.
NOTE: Only sanitizing cycles have been designed to meet
the requirements of 6 for soil removal and sanitization
efficacy. There is no intention, either directly or indirectly,
that all cycles have passed the sanitization performance
test.
14