Sears Kenmore Elite 630.1399 Series Use & Care Manual page 18

Spray arms
Lime scale and contaminants in the rinsing water may block
nozzles and bearings on the spray arms.
o Check outlet nozzles on the spray arms for blockages.
Unscrew the upper spray arm.
Remove the lower spray arm.
Waste wafer pump
Large food remnants in the rinsing water not retained by
the filters may block the waste water pump. The rinsing
water does not get pumped out and covers the filter.
in this case:
* Disconnect the appliance from the power supply.
* Remove the filters.
* Scoop out water, use a sponge if required.
* Using a spoon, pry off the pump cover (as illustrated)
until it clicks, then grip the cover by the lug and first pull
it upwards until it resists and then pull it out forwards.
/
* Clean the Exterior Door Panel
Colored Doors
Use only a soft cloth that is lightly dampened with soapy
water.
Stainless Steel Doors
Use a soft cloth with a non-abrasive cleaner (preferably a
liquid spray) made for cleaning stainless steel. For the best
results, apply the stainless steel cleaner to the cloth, then
wipe the surface.
• Clean the Interlor
Hard water minerals can cause a white film to build up on
the inside surfaces, especially lust beneath the door area.
Do not clean the dishwasher interior until it has cooled.
Wear rubber gloves. Do not use any type of cleanser other
than dishwasher detergent because it may cause foaming or
sudsing.
• Make a paste with powdered dishwasher detergent on
a damp sponge and clean OR
• Use liquid automatic dishwasher detergent and clean
with a damp sponge.
Clean the Door Gasket
Regularly clean the door gasket with a damp cloth to
remove food particles and other debris. Also clean the door
seal, located inside the dishwasher at the bottom of the
door.
• Winterizing Your Dishwasher
if your dishwasher will be unused for an extended period
of time in a location that experiences freezing temperatures
(e.g., in a holiday home or through a vacation period), have
your dishwasher winterized by a qualified service center.
* Check inner compartment and remove any foreign
obiects.
* Place cover in the original position, press down and
engage.
* Install filters
18