Table of Contents
Advertisement
Dishwasher
did
nat sanitize
Dishwasher nat
draining
Etching
(permanent
cloudiness)
_'Sudsing"
Water
is still too
hard
1.
Did not run a sanitizing
cycle
2.
Opened
door mid-cycle
1.
Kinked
or Crushed
Drain Hose
2.
No high Loop in Drain Hose
3.
Food Disposer
plug not removed
4.
The airgap
may need
cleaning
5.
A home plumbing
issue.
1.
Type
of glass - some glassware
is sensitive to
temperature
2.
Too much detergent
3.
Too much detergent
and!or
wrong
type
of
detergent
and/or
wrong
brand
of detergent.
1.
Water
softener
system is deactivated.
2.
Little or no salt in the salt dispenser
3.
Salt dispenser
setting
is too low.
1.
Select a cycle that is intended
to sanitize.
See
Dishwasher
cycles and options
section for more
information.
2.
Do nat open the door
while the wash cycle is running.
1.
Check Drain Hose for proper
installation.
Note: In the
Installation
Process, do not rotate
the Drain Hose after
it is attached
to the dishwasher.
Refer to Installation
Instructions
for details.
2.
Make
sure that a portion
of the Drain Hose is at least
20" from the floor.
Refer to Installation
Instructions
for
details.
3.
If your Drain Hose is attached
to the Food Disposer
make sure the plug in the Food Disposer
was removed.
4.
Clean
the air gap
periodically
to ensure
proper
drainage
of the dishwasher.
With
most types,
you lift
off the chrome
cover.
Unscrew the plastic cap. then
check for any soil buildup.
Clean
if necessary.
5.
In this case, a certified
plumber
would
need
to check.
1.
Make
sure that glasses are Dishwasher
safe. Select
a
cycle that does nat get as hat. Do nat use the Heated
Dry option.
2.
The amount
of detergent
is based
on the hardness
of
the water
deliveried
to your dishwasher
and the amount
of food
soil present.
If you pre-rinse
your dishes and!
or have soft water
you should
reduce
the amount
of
detergent.
See Owners
manual
for details.
3.
Reduce or change
the type!brand
of detergent
you are
using. Note: Do not pre-rinse
dishes. Scraping
excess
food
soils is all that is required.
1.
Make
sure that the amount
of salt dispensed
is set
between
"'H:01 " and "'H:07".
Refer to the Water
Softening
System
and Salt section of this manual.
2.
Check to see if the "'salt refill"
LED is lit. If so, refill
with
salt immediately.
21
Advertisement
Table of Contents
