Sears Kenmore Elite 630.1399 Series Use & Care Manual page 13

Toachieve properdrying,always usea liquidrinse agent,
even if yourdetergent contains a rinse agentor drying
additive.
NOTE: The dishwasher has a Rinse Agent LED that
illuminates when the Rinse Agent is law.
NOTE: The LED will not illuminate if there is enough rinse
agent in the dishwasher.
Setting amount of rinse aid:
The amount of rinse aid dispensed can be set from "r:O0" to
"r:06". The default factory setting is "r:05".
NOTE: Do nat change the amount of rinse-aid unless there
are streaks (select lower setting) or water stains (select
higher setting) visible an the utensils.
, Always use Rinse Agent even if your detergent contains
rinse agent.
, Add rinse agent when the LED an the control panel
illuminates.
ilyiiiiily ii iii i iiii ............
iiiii ii!i iii IIIIIIIIIIIIII IIIIIIII IIIIIIIII
Add liquid rinse agent to the dispenser as shown until the
rinse agent reservoir is full. Wipe up any excess rinse
agent that puddles when the dispenser reservoir is full to
prevent sudsing.
, Open the door.
, Press the "POWER" button.
, Press and hold "CHINA GENTLE" and "START" button
until the display shows "H:OO"
, Release both buttons. The LED for "CHINA GENTLE"
flashes and the display shows "H:O4".
, Press "QUICK RINSE" until the display shows "r:05".
To change the setting:
, Press "QUICK RINSE" until you reach the desired setting.
"r:06" is the highest setting and "r:O0" deactivates it.
, Press START to save the setting.
, Close the door.
To turn off the refill rinse aid indicator:
, Follow the instructions described above and set the
value to "r:O0".
The rinse aid refill indicator is now turned off.
After filling the rinse agent dispenser, the indicator light will
go out in a few minutes after the dishwasher door is shut.
13