Installation - Eaton ESR5-NO-41-24VDC Manual

3 Installation

CAUTION
Installation requires qualified electrician 
A ESR5-NO-41-24VDC may only be fitted and connected by a
qualified electrician or a person who is familiar with electrical
installations.
WARNING

Danger due to electric voltage!
All installation work must be carried out with the entire installa-
tion in a de-energized state.
Always comply with all applicable country-specific safety rules and regula-
tions:
▶ 1.Switch off and isolate
▶ 2.Secure against retriggering
▶ 3.Verify isolation from the supply
▶ 4.Earthing and short-circuiting
▶5. Cover or enclose any neighboring live parts.
What to do before turning the device back on
▶ 1.Remove all tools and materials
▶ 2.Leave the danger zone
▶ 3.Remove the short-circuiting and grounding at the area where work was
performed and then elsewhere
▶ 4.Disconnect the ground wire from the system components first, then
from the ground
▶ 5.Do not touch system components or cables without a ground wire (if
there was one previously) anymore
▶ 6.Reinstall all safety covers, safety enclosures, safety labels, and safety
signs.
▶ 7.Do not remove safety measures at switching points until you get the all-
clear for the areas where work was performed
ESR5-NO-41-24VDC 11/23 MN049016EN Eaton.com
3 Installation
22