Brake Pad - LeMond Fitness RevMaster 15100 Service Manual

brAke PAd removAl/instAll
Use 3mm hex wrench & brake pad oil (or 3-In-One Multi-purpose oil) .
With the fender assembly off the bike use a 3mm hex wrench to remove the two screws that hold the
brake pad to the fender . Remove the pad and scrape away any of the foam padding still stuck to the
fender . Peel off the backing of the foam on the new brake pad to expose the sticky surface of the foam .
Screw the new brake pad onto the fender with the foam side facing the fender and press across the
length of the pad so the foam sticks to the fender . Coat the surface of the brake pad with brake pad oil
and allow it to soak into the pad . Repeat the process 4-5 times or until the pad is saturated with oil (but
not dripping) . The fender assembly is now ready to be installed on bike .
Installation
Apply Loctite to the male portion of the bolt that holds the fender to the frame . Lift up on the brake rod
and slide the fender assembly over the top of the flywheel and line the holes in the back of the fender
with the hole in the frame . Insert the female section of the bolt from either side, through the hole in the
fender and into the hole in the frame . Then insert the male portion of the bolt from the other side and
thread the two parts of the bolt into each other . Gently snug the bolt down with hex wrenches but be
careful not to over tighten or the bolt will break . Ride and test bike with resistance .
l
Pg. 26
RevMaster Service Manual