Installation Check List; Stabilizer Bars; Pedals; Handlebar - LeMond Fitness RevMaster 15100 Service Manual

Table of Contents

Advertisement

INSTALLATIoN ChECk LIST

stAbilizer bArs

Check that the mounting screws, four M8 x 20 screws attach the front stabilizer bar to the frame, and
four more attach the rear stabilizer, are properly aligned (not cross threaded) and use the correct
washers . Check that the top mounting screws use an M8 star washer, and that the bottom mounting
screws use a curved washer, with the concave surface facing the stabilizer . Check that the screws are
securely tightened .

PedAls

Check that the pedals are not cross threaded into
the crank arms . The right pedal has a normal thread
pattern (clockwise to tighten, counter-clockwise to
loosen), and left pedal has a reverse thread pattern
(counter-clockwise to tighten, etc .) . When installing
the pedals, use your fingers to start the pedal so you
can feel if you are cross threading them into the crank
arms . Use a 15mm box end wrench to tighten the
pedals after you have installed them finger tight .

hAndlebAr

When the handlebar is installed, the slider plunger (see figure below) may become dislodged . If this
happened during assembly, the adjustment lever alone will not provide a sufficient grip to secure the
handlebar to the mounting track; if threaded up against the mounting track, it could damaging the
track .
If the slider plunger is missing, see Handlebar Adjustment and
Assembly below for instructions on replacing the slider plunger
and installing the handlebar .

seAt slider

Ensure that the large brass washer is installed on the adjutment
handle attaching the seat slider to the seat post . (See Figure 1 .)
Apply a small amount of grease to the threads to allow adjustments .

wAter bottle holder

The water bottle holder is attached with an M5 countersunk screw to the bottle holder front mount . If
the bottle holder is not already attached, remove one of the one of the M5 countersunk screws from
the front mount with a 3mm hex wrench and use it to attach the bottle holder to the bracket .
Left Crank
Left Pedal
Insert
Counter-Clockwise
Slider Plunger
Pg. 11

Advertisement

Table of Contents
loading

Related Products for LeMond Fitness RevMaster 15100

This manual is also suitable for:

Revmaster 15200Revmaster 15300Revmaster 15400

Table of Contents