Table of Contents
Advertisement
PedAls
Use a 15mm open end wrench or pedal wrench to install and remove pedals .
Installation
One pedal will be labeled (L) for left and the other pedal (R) for right . Also note the left pedal is reverse
threaded . Carefully thread the left pedal into the left crank arm by turning counterclockwise and tighten
by hand being careful not to cross the threads . With the same mindfulness tighten the right pedal into
the right crank arm . Then firmly tighten down both pedals with the wrench .
Removal
Unscrew the left pedal by turning it clockwise with a wrench . Unscrew the right pedal by turning it
counterclockwise .
Pg. 16
RevMaster Service Manual
Advertisement
Table of Contents
