Sony MDS-JB940 Operating Instruction page 15

Operations you may want to do during
recording
To Press
Stop recording =
Pause recording i"
'Resume recording after ew
pausing
RER EJECT & afier sopping
[Eene mo Es
To change the display while recording
Press DISPLAY/CHAR (or DISPLAY) repeatedly to
change the display.
Each press of the button changes the display as follows:
'Track number and recorded time of the current
track
4
Level of the input signal (setting value of the
recording level)
'Sampling frequency indication
"FS =- kHz" appears while the analog signal is input.
When you pause recording
'The track number increases by one. For example, if you
paused recording while recording track 4, the track
number will be $ when you resume recording.
To prevent accidental erasure of the recorded
materi
'To protect an MD recording, slide the record-protect tab in
the direction of the arrow (see illustration below) to open
the slot. To enable re-recording. close the slot.
Record-protect tab
Slide in he direction
ot arrow
© You can play the tracks you have just recorded
Press > immediately after stopping recording
"The deck starts to play from the first track of the material just
recorded.
"Ë You can play trom the first track of the MD after
recording
4 Press BB again afier stopping recording.
2 Pres >.
The deck starts to play from the first rack of the MD.
Note
You cannot record over existing material when Shuffle Play
(page 27) or Program Play (page 27) has been selected
"Impossible" appears in the display at this time.
Recording to an MD | 15 °°.
san 01 Supioso I