Setting The Clock - Sony MDS-JB940 Operating Instruction

esse
To connect a CONTROL A11! compatible
'component
ran
For details, see "Using the CONTROL AIL control
system" on page 44.
'To connect the AC power cord
Connect the AC power cord of the deck to a wall outlet.
pavers bumo |
Note
H you use a timer, connect the AC power cont to the outlet of the
Demonstration mode
When you tum on the MD deck and there is no MD in the
deck, demonstration mode is activated automatically after
about ten minutes, To deactivate the demonstration mode.
press any button on the deck or on the remote.
Ñ To turn ott the demonstration mode
Pres M and CLEAR simultaneously when there is no MD in the
deck
Demo ON" appears in the display
am on the demoestation mex again, perform same
procedure described above
'Denno On" appears in the display
Setting the clock
'Once you set the MD deck's internal clock, the MD deck
will automatically record the date and time of all
recordings. For USA and Canadian models, date is
displayed in the order of month, day, year, and time on a
-hour clock. For European model, date is displayed in
the order of day, month, year, and time on a 24-hour clock.
Note
The display windows below are of USA and Canadian modes
MEMUNO YES
1 Wnile the deck is stopped, press MENUINO twice,
tup Menu" appears in the display.
2. Turn AMS (or press 144 />»i ropoatediy) until
"Clock Set 2° appears, then press AMS.
omh (or day) indication starts flashing-
Koza 00v
3 Tur AMS (or press 44 ropoatediy) to enter
the current day, then press AMS.
'The month (or day) indication stops flashing, and the
day (or month) indication starts flashing.
[onoo
(a
4 Repeat step 3 to enter the month, day, year, hour,
rie
Wed 12-00
=
When you enter the minute, the set date and time
appear again followed by "Complete", and the clock
settings are completed
Changing the clock setting(s)
1 Do steps 1 and 2 above.