Ⅸ. Introduction To The Host Computer - Ebyte E52-400/900NW22S User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd..
Ⅸ. Introduction to the host computer
Users can use the host computer provided by the official website to configure the module. When using it, the user

needs to virtualize the module serial port into a COM port. The host computer interface is as shown below. The
upper part is the basic function buttons to set the COM port, baud rate, and calibration. By checking the bit, you can
perform operations such as parameter reading, writing, restoring defaults, and restarting the module. The lower left
side is the parameter area. The right side below is the log area, which will print and display the corresponding AT
commands executed. Users can operate the module based on the logs.
The second page is the multicast-related group address settings. Users can add, delete and query multicast group

addresses. The multicast group address supports up to 8 different addresses.。
Figure 8.3.1 Remote broadcast configuration steps
27
CopyriCopyright ©2012–2023, Chengdu Ebyte Electronic Technology Co.,Ltd.
E52-400/900NW22S User Manual