Introduction To Remote Broadcast Configuration - Ebyte E52-400/900NW22S User Manual

400/900mhz 160mw ttl lora mesh wireless networking module

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd..

(Unicast);

Step 3: Module A uses the "AT+DST_PORT=14,0" command to modify the target port to the remote parsing AT

command function;

Step 4: Module A sends the AT command "++AT+PANID=4660,0". If sent successfully, SUCCESS will be returned;

Step 5: After receiving the instruction, module B will output the execution result of the corresponding instruction

through the serial port after waiting for a route establishment timeout, and respond with "+OK:" or "+FAIL:" through the

radio frequency, and will send the current module The parameters are sent via radio frequency, and

returned if the transmission is successful;

Step 6: Module A receives the module information responded from module B and outputs it through the serial port.

8.3 Introduction to remote broadcast configuration

The basic steps for remote broadcast configuration are as follows:



Step 1: Module A uses the "AT+OPTION=3,0" command to change the communication mode to broadcast mode

(Broadcast);

Step 2: Module A uses the "AT+DST_PORT=14,0" command to modify the target port to the remote parsing AT

command function;

Step 3: Module A sends the AT command "++AT+PANID=4660,0". If sent successfully, SUCCESS will be returned;

Step 4: After receiving the instruction, module B waits for a route establishment timeout period and then outputs the

execution result of the corresponding instruction through the serial port.

Figure 8.2.1 Remote single point configuration steps

E52-400/900NW22S User Manual

SUCCESS

will be

Table of Contents