Ebyte E52-400/900NW22S User Manual page 21

Chengdu Ebyte Electronic Technology Co.,Ltd..
generally keeps the default port

the other ports have no function yet.
Multicast radius <rad>

coverage area is.
CSMA random avoidance time<rng>

The longer the random avoidance time, the slower the network response speed, but the lower the possibility of
conflict. If you want to modify this time, you need to pay attention to the response time and conflict probability of
the entire network. It is generally not recommended to shorten this time.
The maximum number of consecutive failures <score>

number of consecutive failures <score>
The smaller the maximum number of consecutive failures <score>
route when a link fails or the communication is abnormal. However, re-establishing the route takes a certain amount of
time, so it is generally sufficient to keep the default. When communication is successful, the current number of failures
will be reset.
The RF automatic reset time <reset_time>

the radio frequency automatic reset time will be reset, which will not affect normal data transmission. This time can
be shortened in places with severe environmental interference. Setting it to 0 minutes will turn off the automatic
restart function.
The default values of broadcast filter timeout <time>

duplicate data frames are received within the
recommended to shorten this time.
The default values of request response timeout <time>

NO ACKUnder unicast, the target device needs to return a response ACK. If it gets a response ACK from the target
address, it will return SUCCESS immediately. Otherwise, it will wait for the
before returning NO ACK.
The more levels of routing devices passed through, the longer
Under the default parameters, about 5 levels of routing devices can be supported.
The default values of routing request timeout <time>

Under unicast, you need to initiate a routing request first, collect the routing information of each device within
routing request timeout <time>, and then initiate another data request after the end.
The routing request timeout <time>
complete completion of the network. If the route is not successfully established, NO ROUTER will be returned.
The greater the number of devices, the longer
parameters, about 50 devices can be supported to establish routes. More than 50 devices need to extend this time through
instructions.
When "OUT OF CACHE" is returned, it means that the sending buffer is full. The sending buffer area can cache 5

items. Under normal circumstances, the buffer area will not be full. It will only occur when the interval between
consecutive sendings is too fast, and all sending data buffers will be forcibly cleared inside the module.
The network protocol layer uses data RSSI to optimize the entire network link. The routing nodes will automatically

select the best routing nodes for routing. Users no longer need to consider signal strength.
1. Only in remote configuration, the target port needs to be changed to port 14, and
is generally kept at the default level
generally keeps the default value of 127
will affect the probability of re-establishing routes.
generally keeps the default value of 5
needs to cover the entire process from the initiation of the routing request to the
2. The larger the
is generally kept at the default value of
is, the shorter the time it takes to re-establish the
at different airspeeds are 15s, 30s, and 60s respectively. When
broadcast filtering timeout
at different airspeeds are 2.5s, 5s, and 15s respectively.
the request response timeout <time>
at different airspeeds are 2.5s, 5s, and 15s respectively.
the routing request timeout <time>
17
CopyriCopyright ©2012–2023, Chengdu Ebyte Electronic Technology Co.,Ltd.
E52-400/900NW22S User Manual
multicast radius <rad>
(random avoidance time is 0~127ms).
3.
minutes. When data is received,
<time>, they will be filtered.
request response timeout <time>
should be. Under the default
is, the larger the
The maximum
It is not
to end
should be.
the