Large Lift Lever - Simplicity RTH Series Operator's Manual

Adjustments
LARGE LIFT LEVER
NOTE
Use this procedure if optionai large iift iever (B, figure
8) is used. If small lift lever (E, figure 8) is used, see
previous procedure.
1. Place the mower in low cut position.
Figure 42. Measurement - Large Lift Lever
2. Measure the distance from bottom edge of lever bracket
to mower deck (figure 42).
3. The measurement should be 5 inches.
4. To adjust, disconnect trunnion (C, figure 43) from lift
chain. Loosen the nut, and turn trunnion to raise or lower
mower. Tighten nut when measurement is correct.
Figure 43. Lift Assembly - Large Lift Lever
A. Chain
B. Nut
C. Trunnion