Adjusting The Seat - Simplicity RTH Series Operator's Manual

Normal Care
Cleaning the Battery & Cables
1. Disconnect the cables from the battery, negative cable
first (figure 19).
2. Remove the battery clamp, then remove the battery.
Figure 19. Battery
A. Positive Terminal
B. Negative Terminal
C. Battery Clamp
3. Scrub the battery, cables, and battery compartment with
baking soda and water.
4. Clean the battery terminals and cable clamps with a wire
brush.
5. Reinstall battery and clamp (figure 19).
6. Connect cables, positive cable first.
7. Coat cable clamps and terminals with grease or
petroleum jelly.
ADJUSTING THE SEAT
Raise the seat deck. While holding the seat, loosen the four
capscrews that secure seat to seat deck hinges. Position the
seat as desired, then tighten the capscrews.
Seat springs can be adjusted for operator comfort. Move
springs forward for lighter operator or toward the rear for
heavier operator.
22