Table of Contents
Advertisement
Setup
Installation of Battery Pack in Handset
Follow the steps below:
1. Remove battery compartment cover by pressing on the indentation and
sliding downward.
2. Align the two holes in the plug with the socket pins, then snap the plug into
place.
3. Snap the battery pack in place with the wires in the lower left corner, along
the bottom of the battery pack.
4. Replace cover by sliding it up into place.
5. Place the Handset in the Charger, and allow it to charge for 12 hours.You
can use the Base Handset or Speakerphone in the meantime.
Note: If you charge the cordless Handset while the Base Unit is not connected to
power, the CHARGING LED on the cradle will flash rapidly.
Note: With a fully charged battery pack, your VT2498 Cordless Handset will
deliver up to 6 hours of continuous talk time, or up to 6 days of standby time (off
the charge cradle, but not in use). Your results can vary, and may be less than
the quoted maximums.
Advertisement
Table of Contents
