Table of Contents
Advertisement
Installation of Battery Pack in Handset
The original Handset that is shipped with your v 2651 system will be automatically
registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned
extension numbers in the following order: HANDSET 2, HANDSET 3, and finally
HANDSET 4.
After a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER
BASE ID to register the new Handset.
Follow the steps below:
.
1
Remove the battery cover by
pressing on the indent and sliding
downward.
.
2
Align the two holes in the plug
with the socket pins. Insert the
plug into socket. Place the battery
pack into the compartment with
the wires coming out of one of
the bottom corners of the pack.
.
3
Replace the battery cover by
sliding it upwards.
.
4
If the new battery pack is not
already charged, place the
Handset in the Base unit, or a
remote charging stand, and allow
it to charge for 12 hours. After
initial charge, a maintenance
charge of 8 hours should be
sufficient.
Setup
Advertisement
Table of Contents
