Set Security Code - VTech vt2461 User Manual

2.
Press RECORD. "Now recording", is announced, followed by a beep. Speak
towards the front of the Answering System (max. length: 90 seconds).
3.
Press any MAILBOX key to stop the recording.
4.
Then OGM replays the message automatically, followed by a beep.
5.
To review a recorded announcement, press MENU key until "Set Outgoing
Message" is announced. Press any MAILBOX key. The current greeting
is played.
6.
To delete a recorded announcement, press ERASE during OGM playback.
You then hear "Outgoing Message has been erased".
NOTE:
If your recording time is less than 2 seconds, your OGM will not be recorded,
and the default greeting will be used.

Set Security Code

The security code programmed into the Answering System is used to gain access
to functions from remote locations. The security code default setting is 19 . You
can select any two-digit code, from 00 to 99.
Answering System Setup
NOTE:
In Announce Only mode, your
outgoing announcement is repeated
before hanging up.
Recording / Playing / Deleting the
Outgoing Messages (OGM)
1.
Press MENU key until the
desired item (Set Outgoing
Message) is announced.
1.
Press MENU unit you hear "Set
security code."
2.
Press TIME/SET to hear the
current security code.
3.
Press SELECT briefly to increase
the security code by 1. Or, hold
SELECT
increase the code by multiples of
10.
4.
Press TIME/SET to confirm your
choice and you will hear the
announcement of the security
code.
31
continuously to