Set Security Code; Set Audible Message Alert - VTech gz 2456 Operating Instructions Manual

Setting up your gz 2456 Digital Answering System

Set Security Code

• When you call your gz 2456 from a remote lacation,
a two-digital security code must be entered to gain
access to functions such as message playback.
The factory preset security code is 19. You can
designate any two digital security code you wish,
from 10 to 99.
• Press the MENU key until you hear "Set Security
Code".
• Press SELECT to hear the current security code.
Every time you press SELECT, the code increases
by 1. Holding SELECT increases the security code in increments of 10. The Base Unit
will display the security code as you program it.
• Press TIME/SET to confirm your choice. The voice prompt will say:"Security code is
XX".
• Press MENU to go to the next programming function, or press PLAY/STOP to exit
programming mode.

Set Audible Message Alert

• This feature provides a beep every 10 seconds at
the Base Unit, alerting you to new, unplayed
messages.
• Press MENU until you hear " Set audible message
alert".
• Press SELECT. The voice prompt will say either
ON or OFF.
• Select ON if you want your gz 2456 to beep every
10 seconds to alert you to any new messages;
select OFF if you don't. The Base Unit will display
On or OF (off) as you make your selection.
• Press TIME/SET to confirm your selection. The voice prompt will say : " Audible message
is on ( or off )."
• Press MENU to advance to the next programming function or press PLAY/STOP to
exit programming mode.
18