Set Security Code; Set Day And Time - VTech vt1970 User Manual

SETTING UP YOUR VT 1970ci DIGITAL ANSWERING DEVICE
• If you would like to re-record your
outgoing message, simply repeat
the above steps.
• If you would like to return to the
factory-set outgoing message:
• Press MENU . The voice prompt
will say "Set Outgoing Message".
• Press PLAY/STOP . The outgoing
message will begin playing.
• Press ERASE while your outgoing
message is playing. The voice
prompt will say "Outgoing Message
has been erased".
• Press MENU to go to the next
programming function, or press
PLAY/STOP to exit programming
mode.
POWER MENU
HS IN-USE SELECT
TIME/
CHARGING
SET
SPARE BATT
ON/OFF
ERASE
MEMO
PAGE
VOL
DIGITAL
900MHz
CORDLESS

Set Security Code

• When you call your VT1970ci from
a remote location, a two-digit
security code must be entered to
gain access to functions such as
message playback. The factory
preset security code is 19. You can
designate any two digit security
code you wish, from 00 to 99.
vt1970ci/hjmannual
• Press the MENU key until you
hear "Set Security Code".
• Press
current security code. Every time
you press SELECT , the code
increases by 1. Holding SELECT
increases the security code in
increments of 10. The Base Unit
will display the security code as
you program it.
• Press TIME/SET to confirm your
choice. The voice prompt will say:
• "Security Code is XX".
• Press MENU to go to the next
programming function, or press
PLAY/STOP to exit programming
mode.
MENU
ERASE
PLAY/STOP

Set Day And Time

• When you first power-up your VT
1970ci (or after the Base Unit
experiences a temporary loss of
power), the Message Window will
flash CL, until the Day and Time
is programmed.
• Press MENU until you hear "Set
Day and Time".
32
32
SELECT to hear the
MENU
SELECT
TIME/SET
1/29/99, 12:51 PM