Advertisement
Example 1
Example 3
Editing and recording the playback pictures
on other VTRs
Press the shadowed buttons.
Press the shadowed buttons alternately.
oaaClirit)
=
eu
INPUT (2)
inpuTo)
outPuT2]
output
output}
output}
Example 2
Example 4
Recording the playback pictures from three
VTRs on three other VTRs at the same
Recording on a VTR only the video or the
Press the shadowed buttons.
time.
audio signal from connected equipment
(possible only in mode C)
i
=
The playback pictures from the VTRs
O
fF : = S =
SHratat
=
connected to INPUT[T}, INPUT 2], and
Only the video signal trom the equipment
Trooa0o
Bloonsg
~~
INPUTI3}, are recorded on the VCRs _
connected to INPUT (iJ and only the audio
"poo
0o
Poll
©
connected to OUTPUT 4], OUTPUT /S?,
signal from the equipment connected to
il:
and OUTPUT [6] respectively at the same
Select only the video or audio signal with the VIDEQ/AUDIO selector,
INPUT [8] are recorded on the VIR
=
Seo
SS
HOHHee
lime
and then press the shadowed buttons.
ted
ti OUTPUTI3)
Dono
Oo
Oo Bln _o
o Haan
4
So fbonfaH
2
fon}
oa
oan
input
se
inpuT@®
HHsbHn
HHH)
om
I
c2
cooooe
googod
ouTPut @)
output
output)
To watch the picture being edited on the
monitor
ouTPuT [3}
Select the monitor to be used and the picture to
be monitored using the MONITOR selector and
the INPUT/OUTPUT selector. See "Monitoring
the Picture from the Video Equipment" on page
34.
To prevent accidental operation during editing
or dubbing
Alter inputs and outputs are designated for all the
equipment, press the MODE LOCK button on the
front panel to ON before starting editing or
dubbing.
When the MODE LOCK button is set to
ON, the MATRIX SELECT buttons,
V = S
switches, AUX AUDIO selectors, PROCESSOR
selectors and MEMORY buttons (page 60) do nol
function even if they are accidentally pressed.
To designate inputs/outputs again from the
beginning
Press the CLEAR button on the front panel.
Alt
the settings of the MATRIX SELECT buttons,
V +
S switches, AUX AUDIO selectors and
PROCESSOR selectors will be canceled—and
you can do the input/output designation all over
again.
To record the signals input from two different
sources alternately
When the input signal is switched to the other
one, set the recording VTR in the pause mode.
Otherwise, the picture may be distorted al the
point where the inputs were switched.
58
Advertisement
