System Wiring Overview - Honeywell MPA2C3 Installation Manual

1. Press the SHUTDOWN button for 5 seconds.
2. Running LED is off, Panel is shut down (hibernate state).
Note: Note: If after shutdown the power is not removed from the panel, to restart the panel,
please press Shutdown button shortly (NOT 5 Seconds).
Note: To completely power off the control unit.
Note: a. When the unit is powered by PSU, first disconnect the battery cable and then
disconnect the AC power cable.
Note: b. When the unit is powered by PoE+, disconnect the PoE+ cable.
Restart the Panel
Note: Before powering up the access control unit, ensure that the access control unit is
properly wired to the readers, doors, interface bus and downstream devices. Ensure
the DIP Switches and jumpers are set for the corresponding readers.
1. Apply Mains power first, then connect the back-up battery or connect PoE+
2. Check the status of Running LED.
•
•
•
Note: If only the battery is connected to the panel without the mains power, then the panel
will not start.

System Wiring Overview

•
•
28
power to the panel.
Green Blinking - license is correct and application is running as 2-door panel
Orange Blinking - license is correct and application is running as 4-door panel
Orange ON - application is checking the license file
2 Door system wiring overview
4 Door system wiring overview
MPA2C3 Installation Guide