Table of Contents
Advertisement
2. Restrictions and warnings
Due to fire hazard, only qualified technicians are allowed to install the system.
No electrical equipment should be placed inside the cabinets unless specifically approved by the
manufacturer.
The cabinets are heavy. Take note of the centre of gravity when lifting.
Handle with care cabinets with glass doors to avoid injuries or damage to the doors.
Cabinet parts may have sharp edges, wear protective gloves during installation.
Do not place cabinets so that they are subject to draft.
Do not place cabinets near a heat source, such as radiators, hot air fans or hot lighting fixtures.
Do not place cabinets in direct sunlight. If necessary, use blinds on any nearby windows.
Note!
Be careful not to damage plumbing fixtures or plinth plate supports on the bottom of the cabinets when lifting.
Never lift cabinets with glass ends from the short end!
Note!
Climbing or standing on the cabinet roof during installation is not allowed.
Note!
If the canopy is equipped with a control unit (optional extra), the cabinet must be handled with special care to
avoid damaging the protruding display.
Note!
When placing the electrical junction box on the cabinet roof, use a protective covering to avoid scratching.
WARNING!
If a defect occurs in the cabinet or cabinet equipment during installation or start-up, or if the cabinet does not
operate normally, make sure that this does not create a hazard to people or property. If necessary, disconnect the
cabinet from the mains and contact the nearest service organisation.
WARNING!
If you suspect a refrigerant leakage, ventilate the premises immediately!
WARNING!
Only licensed professionals are allowed to install refrigerant lines or electrical equipment!
EN DE ES FR PL RU NL FI SV NO DA EE LT LV
4
Advertisement
Table of Contents
