Operation; Switching On The Monitor - Dometic M9LQAHD Operating Manual

No. Description
7 CAM3 socket
8 CAM4 socket
VCC cable (red): Connection to 10 ... 32 V, the
switched plus of the ignition (connected positive,
9
terminal 15) or the positive pole of the battery (termi-
nal 30)
Trigger1: Trigger connection cable to activate the
10
selected camera
11 GND cable (black): Connection to ground
Trigger2: Trigger connection cable to activate the
12
selected camera
Trigger3: Trigger connection cable to activate the
13
selected camera
Trigger4: Trigger connection cable to activate the
14
selected camera
Trigger5 control cable (yellow): Split control cable
15 for activating the split screen (the screen is divided
into 2 parts with any 2 cameras)
16 Video output socket (yellow): Live video output
6.1.5 Connecting the monitor as a
reversing video system
1. Lay the monitor cable on the dashboard.
2. Insert the monitor cable plug (Figure ,2) in
the connection cable socket (Figure ,3) of the
connection cable (Figure ,4).
NOTICE Damage hazard
Ensure that the polarity is correct
when connecting to a voltage
source.
3. Connect the power cable (red) (Figure ,9) to
terminal 15 (ignition).
4. Connect the earth cable (black) (Figure ,11) to
terminal 31 (ground).
5. If the monitor is to be activated when the reverse
gear is engaged, connect the trigger cable se-
lected to activate the rear camera (Figure ,10,
12, 13, 14) to the positive cable of the reversing
light.
6.1.6 Connecting the split screen
control cable
The connection of the Trigger5 control cable
(Figure , 15) activates the split screen.
Connect the Trigger5 control cable (yellow)
to a 10 ... 32 V voltage signal.
7

Operation

NOTICE Damage hazard
Do not apply strong pressure when op-
erating the touchscreen.
NOTE
• Ensure that the engine is running
during operation to prevent dis-
charge of the vehicle battery.
• The monitor buttons, exceped
for the
when they are pressed. The light
switches off if the buttons are not
used for a few seconds.
7.1

Switching on the monitor

NOTE The monitor is automatically ac-
tivated when the monitor is connected
to the power supply. When the touch-
screen does not display an image, the
monitor is in standby.
Press the button or swipe up on the touch-
screen.
The button lights up green. If the monitor is
connected to the vehicle battery, the previous
screen configuration selected is displayed. If the
monitor is connected to the ignition, the System
menu is displayed.
button, light up blue
9