Table of Contents
Advertisement
Components
Description
The lamp is burnt out.
Power cut always stops cleaning. Repeat
cleaning if it's interrupted by power failure.
Problems with Wi-Fi signal
Possible cause
Trouble with wireless network signal.
New router installed or router configuration changed.
The wireless network signal is weak.
The wireless signal is disrupted by another microwave
oven placed near the appliance.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F111 - Food sensor is not correctly inserted into the
socket.
F240, F439 - the touch fields on the display do not
work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the appliance system cannot connect with the
control panel.
Remedy
Replace the lamp, for details refer to "Care and Clean‐
ing" chapter, How to replace: Lamp.
Remedy
Check if your mobile device is connected to the wire‐
less network.
Check your wireless network and router.
Restart the router.
To configure appliance and mobile device again, refer
to "Before first use" chapter, Wireless connection.
Move router as close to the appliance as possible.
Turn off the microwave oven.
Avoid using another microwave oven and the Remote
Control of the appliance at the same time. Microwaves
disrupt Wi-Fi signal.
Remedy
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Check your network connection. Refer to "Before first
use" chapter, Wireless connection.
Turn the appliance off and on and try again. Refer to
"Before first use" chapter, Wireless connection.
Turn the appliance off and on.
ENGLISH
31
Advertisement
Table of Contents
