Manual Auto Operation - Fujitsu GENERAL AWWZ14LBC Operating Manual

MANUAL AUTO OPERATION

Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
REMOTE CONTROL UNIT UNAVAILABLE (MANUAL AUTO OPERATION)
If the Remote Control Unit is lost or the batteries are dead, the air conditioner can be operated provisionally from the indoor
unit.
1. Open the open panel.
Grab both sides of the open panel and open the open
panel until it is held in place. (The panel will remain open
even after it is released.)
2. Press the MAINTENANCE/MANUAL AUTO
button (Fig.3 A) for 3 seconds.
G Press the MAINTENANCE/MANUAL AUTO button (Fig.3
A) and continue to press the button even after a beep-
ing sound is produced.
The OPERATION Indicator Lamp (red) (Fig.2 6) on the
Indoor Unit will light.
The air conditioner will operate in the auto mode (see
page 7). Airflow will be automatic, airflow direction will
be the standard setting, and the thermostat settings will
be the standard temperature.
Stopping MANUAL AUTO Operation
Press the MAINTENANCE/MANUAL AUTO button (Fig.3 A) for 3 seconds.
Air conditioner operation will stop and the OPERATION Indicator Lamp (red) (Fig.2 6) on the Indoor Unit will go out.
En-21
3. Close the open panel.
G Do not operate the air contidioner with the open panel
open.