Advertisement
1.
Introduction
This guide provides instructions on how to manually upgrade the firmware on an iServer 2 device.
To perform an automatic firmware upgrade, factory reset the iServer 2 and connect the iServer 2 to the Internet.
2.
Downloading the Latest Firmware
The instructions below will outline the steps necessary to download the latest firmware files for the iServer 2. The
user should note that there are two download files that will appear when an update is available for the iServer 2.
Step 1: Ensure the iServer 2 has been setup, operational, and that the user has access to a PC or laptop with a
web browser.
Step 2: Navigate to the iServer 2 webserver login user interface by entering one of the following URLs into a web
browser search bar:
http://is2-omegaXXXX.local
(the XXXX should be replaced by the last 4 digits of the iServer 2 device MAC address; located on the
underside label of the device)
Figure 1: iServer 2 device label
or
Enter the IP address assigned to the iServer 2 by the local-area network it is connected to.
(Example: http://XXX.XXX.X.XXX the X should be replaced by the numerical values that make up the IP
address of the connected iServer 2 device)
Step 3: Log in to the iServer 2 webserver.
Figure 2: iServer 2 webserver login
4
iServer 2 Firmware Upgrade Guide
Advertisement
